Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

In honor of D Day
#1

As a kid in the 50's I remember the incredible amount of WW II
surplus equipment available to the public.
This included every type of electronic equipment imaginable and it
was labeled JAN (joint Army-Navy) made by Philco, GE, RCA,
Ken Rad, National Union, Westinghouse and others.
Its amazing how sophisticated and dependable this equipment was from an industry barely out of its infancy, I guess it had to grow up
very fast.
#2

I have a lot of war time issued tubes, VT's. I look at some of the old timers left from WW2 and they remind me of my Dad. Did what they had to do. My father told me that not only did most people celebrate the war ending but that a lot sort of viewed the Depression and the War as one big trial, they finally felt like things were looking up. We would not have what we do if they had failed.

Paul

Tubetalk1
#3

All tube-radio aficionados need a small, clean JAN example, like an ARC-5 receiver or transmitter. They represent the most perfect examples of beautifully hand-wired electronics. Having aluminum chassis', they can be found looking just like the did 70 years ago.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently 7853 online users. [Complete List]
» 1 Member(s) | 7852 Guest(s)
Avatar

>