Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Please be specific in your post subjects.
#1

Please be specific in your questions, as well as the subject title you give your questions. Specific questions will generally be answered quicker than those of a generic nature.

Good subject title: How do I test a Type 45 tube from my Philco 90?
Bad subject title: Philco Radio

Also, please do not make multiple posts asking the same questions. This is merely a waste of bandwidth. A lot of us have jobs - and lives - that prevent our being at the computer 24/7. Please be patient, someone will post when they can. It is OK to "bump" your question, if necessary, by merely typing:

bump

as a new post in your thread to help bring attention to it.

This should not be construed as picking on anyone. The questions, comments, and contributions of everyone here are all very much appreciated.

Thanks.  Icon_biggrin




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM

[-]
Who's Online
There are currently 1419 online users. [Complete List]
» 1 Member(s) | 1418 Guest(s)
Avatar

>