Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Boat Anchor?
#16

I don't even think that you need a diagram for this thing, it looks like standard straight line TRF set, a couple of micas, some interstage transformers, coils, a grid leak, and a paper cap. You could likely use one for another set with the same tubes and find 95% of what you need. I would try contacting the company yourself about their radio business, sometimes employees make up stories like that because they can't be bothered finding out.
Regards
Arran
#17

I'm pretty much a novice in the learning stages do alright with the 30's-40's but mostly its Test the tubes, recap, replace out of spec resistors, wound a field coil and mend some speaker cones so everything is on a learning curve. I use this forum and the antique forum for searches and questions and recently joined the radio club down here (Atlanta area). Almost have a full set of the rider's much easier on the eyes than looking online.
Eric
#18

A simple way to tell if it's a boat anchor, wood floats, iron sinks!
Sure looks like a keeper to me! hope you restore it!
#19

yup, can't touch it yet have a couple of other ones ahead but thought I would try to get my research started as there seems to be so little out there on them.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 3273 online users. [Complete List]
» 3 Member(s) | 3270 Guest(s)
AvatarAvatarAvatar

>