Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

can anyone identify this model
#1

            Any help identifying this model? It has a small red light in the front and two hidden toggle switches. No sticker or model number that I can find. Please help!!
#2

40-201:

http://www.philcoradio.com/gallery/1940c.htm#h

But, it should have only one toggle switch under the left side of the dial, not two toggle switches!

That is one of my favorite Philco consoles. Very neat styling, and a very good performer as well, once you deal with the usual rubber-covered wiring issues.

--
Ron Ramirez
Ferdinand IN
#3

Thanks!! It does have two toggles one right one left. It has a little red light I thought it might be a mystery control?
#4

It should not have a toggle switch on the right; that one was added by someone after the set left the factory. Radio-phono switch, maybe?

No, the 40-201 is not a Mystery Control set.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! GaryGarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4205 online users. [Complete List]
» 3 Member(s) | 4202 Guest(s)
AvatarAvatarAvatar

>