Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picked Up Two Consoles Today
#1

This last Friday, I was bringing a Canadian Viking RM-370 back toa shop for this nice lady that works there. Because of continuing construction due to more flooding and road repair work I took a different route. Saw this antique shop and decided to check it out for a few minutes.

Walked in the door and lo and behold there are TWO consoles sitting in the place. A Philco 40-180 right by the door and a little further in is a set with a big honking curved glass dial! Looked it over and chatted with the owner for a bit and left. Got back home and started checking out the other radio. It is an RCA 813K which evidently are fairly hard to find.

Soooo.....I went back today to look again and the price tag on the RCA was $75. Asked what the best CASH price was today and he said $50---SOLD!
Then his partner says why don't you take the Philco too? You can have that for $25----OK!

So two new consoles and now to figure out where they will go. Some pics of the RCA. Needs some help on the case and the tenite bezel is broken as almost all of them are. Also on the very back is a bakelite piece that is broken and I will have to figure out if I can make it usable or try to find another.
[Image: http://i1185.photobucket.com/albums/z345...1e21e0.jpg]
[Image: http://i1185.photobucket.com/albums/z345...3b289e.jpg]
[Image: http://i1185.photobucket.com/albums/z345...2c41f2.jpg]
[Image: http://i1185.photobucket.com/albums/z345...35234e.jpg]
[Image: http://i1185.photobucket.com/albums/z345...554fce.jpg]
[Image: http://i1185.photobucket.com/albums/z345...304308.jpg]
[Image: http://i1185.photobucket.com/albums/z345...ef3d37.jpg]

Gene
#2

RCA, "all the way"! Does it also warn you that Will Robinson is "in trouble"?
#3

That 813k is a nice set.
I have an 816k that looks the same, but it has 16 tubes, and the cabinet is a little bigger.
You can heat a room with these sets. They throw off a lot of heat.
Great sound also.
I re-finished mine. It looks great and sounds great too after a full re-cap etc.
Good luck with it.
murf
#4

Great scores! Icon_thumbup

No matter where you go, there you are.
#5

I have to move to the "right" coast. Would never find such great buys here. Really nice score.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#6

Thanks for the kind words!

I don't know about Will Robinson, but I thought that was kind of neat to have the words in the station preset spots. Evidently the owner never put any station id's in the spots.

Gene
#7

That RCA is sweet, got some of that Jetson's design theme going.

Thanks,

Mike

Cossor 3468
GE 417A
Philco 118H
Radiola 17/100
Scott 800B6
Silvertone 6130
Stromberg 535M
Truetone D1952

#8

It looks like that broken Bakelite part is a switch made by Cutler-Hammer, I'm not sure how common or unique it is though. My guess is that it's purpose is to either kill the motor when the dial gets to the end of travel, or reverse direction. Fortunately the mechanism is very straightforward compared to an Airline (Wells Gardner) automatic tuning mechanism.
Regards
Arran
#9

Wow you will love the RCA-813. I have a RCA 816 and love it. Plays nice and strong.. Should not be too much difference to mine. And yours cost a whole lot less also.....Godd luck with it!
#10

Agree with everyone, the 813K is a pretty good set!!

Nice score!!Icon_thumbupIcon_clapIcon_wave




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4846 online users. [Complete List]
» 2 Member(s) | 4844 Guest(s)
AvatarAvatar

>