Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-608 bol
#1

hey guys
i purchased 2 sales listed as philco speakers 1 was a steal other inflated by seller but still cheep.
question is i belive they are mic`s as i have seen them before . 1 has a wire that goes to black box at top in rear of cabnet i opened it up looks like speaker to me ??


Attached Files Image(s)
   
#2

I bet it is intended as a mic but is just a small speaker. The low Z is boosted by the box which is an input transformer.
#3

Almost all passive electrical machinery is reciprocal.
#4

Yes. I seem to recall (in the dark, distant past), during "experiments", I was able to use a speaker as kind of a microphone. Icon_crazy Odd, but semi-effective. Icon_wtf Could be a hybrid?
#5

Dunno about that, but a small PM speaker makes a very good microphone, just use an output transformer in reverse. Done all the times in old time intercoms. In fact they sometimes used 45 ohm PM speakers to minimize losses in wiring from remotes to masters. Dunno about modern ones though.
#6

thanks guys
i only seen one with the radio for sale but was way to expencive for me
i see them on ebay but no cords as this one has cord i see where it goes .it dosen`t say any about it on my schamtic`s
now all i need is plater to motor cupler and it is complete
amazing a speaker can be a mic too!!
sam




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2716 online users. [Complete List]
» 4 Member(s) | 2712 Guest(s)
AvatarAvatarAvatarAvatar

>