Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-608 bol
#1

hey guys
i purchased 2 sales listed as philco speakers 1 was a steal other inflated by seller but still cheep.
question is i belive they are mic`s as i have seen them before . 1 has a wire that goes to black box at top in rear of cabnet i opened it up looks like speaker to me ??


Attached Files Image(s)
   
#2

I bet it is intended as a mic but is just a small speaker. The low Z is boosted by the box which is an input transformer.
#3

Almost all passive electrical machinery is reciprocal.
#4

Yes. I seem to recall (in the dark, distant past), during "experiments", I was able to use a speaker as kind of a microphone. Icon_crazy Odd, but semi-effective. Icon_wtf Could be a hybrid?
#5

Dunno about that, but a small PM speaker makes a very good microphone, just use an output transformer in reverse. Done all the times in old time intercoms. In fact they sometimes used 45 ohm PM speakers to minimize losses in wiring from remotes to masters. Dunno about modern ones though.
#6

thanks guys
i only seen one with the radio for sale but was way to expencive for me
i see them on ebay but no cords as this one has cord i see where it goes .it dosen`t say any about it on my schamtic`s
now all i need is plater to motor cupler and it is complete
amazing a speaker can be a mic too!!
sam




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! GaryGarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4270 online users. [Complete List]
» 2 Member(s) | 4268 Guest(s)
AvatarAvatar

>