Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46LW
#1

i would like to know if anybody knows the value or where can I find more information about this old radio from Canada, is a Philco 46LW code 121 in working conditions thanks.
#2

Hi and Welcome to the Phourm
Most of the folks deal with the US sets. There are a few CA members that may be able to give you some ideas. Would say just in general condition will weigh alot in terms of value. Some pics would be good just to see it's condition
Terry
#3

is in working conditions, I will upload pictures later but I was looking at the pictures that philco page has and I couldn´t find the exact one. thanks
#4

Did you look at the page on Canadian Philco radios on this site?

http://www.philcoradio.com/world/canada.htm

There were four different model 46 sets made in Canada in the 1941 season. One looks like a PT-2, another looks like a PT-4. Two others (46TL and 46TLI) are sets which I have not seen and do not have a visual reference to.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! GaryGarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4191 online users. [Complete List]
» 3 Member(s) | 4188 Guest(s)
AvatarAvatarAvatar

>