Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Diference between 45F and 45L
#1

Hi All;
Since my Philco 45 is a chassis Only..
Can anyone tell me What is the Difference between the Philco 45F and the Philco 45L ??
I know mine was not origionally a Philco 45C, as the Speaker is Not mounted on the Chassis.. My Speaker is 7.5 inches edge to edge and a 6.0 inch cone.. It looks like it was reconed, and it has only one small partial hole, probably from a small bolt..
THANK YOU Marty
#2

See http://www.philcoradio.com/assets/setindex.pdf
45F is a console model
45L is a lowboy model
#3

Hi All;
Wow, I've never seen this list..
Now I have to figure what is the difference between the Console and a lowboy.. I'll just have to look at some pictures..
THANK YOU Marty
#4

See Ron's photo gallery:
http://www.philcoradio.com/gallery/1935a.htm#v
and
http://www.philcoradio.com/gallery/1935c.htm#i
#5

Hi All;
Does Anyone have a picture of a Philco 45F Console, so I can see the Difference between an F and an L ??
THANK YOU Marty
#6

Marty, see my post just above yours.
#7

Hi All;
Thank You Klondike, You were posting Your Links at about the same Time I was asking the Question..
So, a Console is basically a LowBoy withOut Legs, Right ??
THANK YOU Marty




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>