Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco radio and phono
#1

        I have just acquired a Philco radio and phono and cant seem to find out anything about it.. I would appreciate any help I can get. Thank you so much!!
#2

Hi and welcome!

Your Philco looks very similar to model 50-1720.

http://www.philcoradio.com/gallery/1950.htm#r

Not exactly the same, but the closest I could find.

--
Ron Ramirez
Ferdinand IN
#3

Sassy, I give you an "A" for being able to post a picture and a "D" for the quality. You really need to get a nice camera (cheap). Cell phones can be good if done right. Now, someone will help with the proper model number, as for value, depends on who wants it and where you live. Shipping would cost a lot more than the value of the radio. If you were next door, I might take it as a gift. Not certain why I would do that.
The important thing is does this radio have some value to you? Like been in the family for years. If so, you could either get someone to make it safe to run (electronics) or if you wish to get into a little soldering, make it safe yourself for very little money.
I would say the value would be to have someone pick it up for free or put it at a consignment store for maybe $50. Doubt it will sell. It is just not a radio of any interest to collectors but certainly one for someone who might like a nice accent piece in their house.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#4

Thanks for the info.. with that being said guess ill shabby chic it and make it an accent piece then and sell for $125 thanks again. Have a great day!!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4436 online users. [Complete List]
» 2 Member(s) | 4434 Guest(s)
AvatarAvatar

>