Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

MORE Phonograph Woes
#1

Anyone know where I can go to find a needle cartridge for a 1946 Philco D-10A phonograph? FYI it is mounted in a Philco 46-1209.
#2

If that unit uses a Piezoelectric, Rochelle Salt, crystal cartridge, like my 76A/46-1201, then the cartridge may also be stone cold dead.
Regards
Arran
#3

West-Tech told me they were very hard to come by.....
#4

You would pretty much have to substitute it with a more modern cartridge, or rebuild the old one, unless it is one of those magnetic types. This is part of the hold up with my Bing Crosby, that and a wonky mercury switch.
Regards
Arran
#5

I have a 47-1230 D-10A phonograph with Dynamic cartridge. If it takes the same needle, which it sounds like it does, I contacted this ebay seller and he sold me this needle... http://www.ebay.com/itm/Vtg-NOS-Philco-D...0899675089 . He might have another if you want to contact him on ebay. Warren
#6

I clicked the link but was unable to pull it up.
#7

Hmm, lets try this one.. http://www.ebay.com/itm/271292984355?ssP..._262wt_880 This one should work... contact the seller, when I got mine the auction was ended but I contacted him and he said he had more than one and sold me one.
#8

Thanks, I'll give it a try!
#9

No Problem,, I would be interested in knowing how it works out. Icon_e_smile




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM
HiFi (Chifi) tube amp build - but my own design.
:lol: We need to start a singing radio group! I play the guitar, so maybe get a few vocals? Anyways, Mike, I did try mou...TV MAN — 05:56 PM
HiFi (Chifi) tube amp build - but my own design.
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM
Shadow Meter Bulb
I did try an LED bulb in place of the original but wasn't impressed with the amount of light on the dial. Seems like it ...RodB — 03:51 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Would mounting he transformer vertically change the hum, if used without additional parts? Also, in these amps...morzh — 02:25 PM
Shadow Meter Bulb
Gary I doubt it would introduce any noise. We use similar lamps for the panel indication, 12V AC lamps: they are LEDs...morzh — 02:15 PM
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM

[-]
Who's Online
There are currently 6656 online users. [Complete List]
» 1 Member(s) | 6655 Guest(s)
Avatar

>