Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 37-600 37-602
#1

hi guys and Brenda
I have a 37-600 and bought what was to be another for parts but tubes are deferent has 25a6g and 25z6g so looking seams to be a 37-602 ? why people take stickers of ill never under stand cabinets look same but chassis are very different http://www.nostalgiaair.org/PagesByModel...013206.pdf
http://www.nostalgiaair.org/PagesByModel...013207.pdf
think ill redo both now still looking for darn knobs question which performs better ?
thanks sam
#2

The '600 is like the 80 and 84 a superhet w/a regen detector. The 602 is very different as it is a full superhet. The '602 is the better of the two. The model 600 and 602 use the older large pin tubes. The 37-600 and 37- 602 use the newer octal tubes and share the same cabinet. Knobs are very hard to come by for these sets. There different from all the other Philco knobs.
Terry




Users browsing this thread:
[-]
Recent Posts
Zenith H725
David - I think I understand but what units are you discussing (Low of 1.7, high of 3.9)? Budget constraints for Ham ...EdHolland — 01:43 PM
My Philco 37-116 Restore
You're doing great. I wish I could be more involved, but my mind is right now preoccupied with the reason I am here in ...morzh — 12:21 PM
My Philco 37-116 Restore
Hope you guys are still with me. I have moved on to the alignment. I completed the IF alignment which was pretty muc...dconant — 10:47 AM
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM

[-]
Who's Online
There are currently 1016 online users. [Complete List]
» 1 Member(s) | 1015 Guest(s)
Avatar

>