Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 87 Tube Substitution?
#1

Newbie here with a model 87 lowboy.

My 280 tube is broken. Is there substitution tubes I can use? The 280 is pretty expensive.
#2

280 is a plain 80, later known as 5Z3. The globe shape of the older 280 is what drives the cost up so high.

GL
#3

Thanks Exray! I still have a lot to learn, but I'm working on it.
#4

I had written an E-mail to Radio Daze about substituting the 5Z3 for my 280 and here is the reply:

We wouldnt suggested the substitution because it draws more amps from the amp - roughly 50% more. They will physically fit though.

Will there be a problem with the draw of more amps?
#5

Possibly - the old original power transformer, now running hotter to begin with at 120 volts on primary instead of rated 110VAC, will possibly overheat with even more stress on the rectifier secondary.

Just use a type 80, which is what the transformer is rated at.

Chuck




Users browsing this thread:
[-]
Recent Posts
Philco 610B oscillator wiring
I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM
Zenith H725
Good points, Arran. I haven't encountered this problem with any other radio (all earlier vintages), so am learning here....EdHolland — 05:32 PM
Zenith H725
Ed; One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM
Philco 610B oscillator wiring
Do you know what run # your chassis is? It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM
Need to purchase some accessories for restoration of my Old Philco Radio
COLLEAGUES, Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM

[-]
Who's Online
There are currently 1842 online users. [Complete List]
» 2 Member(s) | 1840 Guest(s)
AvatarAvatar

>