Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Worth going to look at?
#1

45L about an hour from me. Asking price is $100.

http://lasvegas.craigslist.org/atq/4283816801.html

John
Las Vegas, NV USA
#2

Worth? Absolutely.
$100? If you really want it, otherwise personally I would haggle it down.
#3

I would pay 40-50 for that. Its Vegas!, wanna gamble on it? Icon_mrgreen

Refinishing is a real pain with the legs. plan on using liquid stripper, a hard bristle brush and a tooth brush.

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#4

I've always liked that cabinet style:

http://www.tuberadioland.com/philco45L_main.html

I know radios are a bit more scarce in your area, but as others suggested I bet you could get that for between $50 & $75.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#5

Agree not an easy cabinet to properly finish. BUT a VERY NICE looking cabinet when right.

The model 45 has BC and a nice fat shortwave band, similar to the 66, but it has one more tube than the 66. They are another example of a low tube count Philco that receives very well!!!
#6

That's what I had thought I found near me a while back. It turned out to be a 66L instead and I just didn't feel like a 2 hour trip at the time. Now I would think the 45L to be more desirable. Hopefully you can haggle a little. Icon_smile

No matter where you go, there you are.
#7

Nice radio.........Go Get It...




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 6570 online users. [Complete List]
» 1 Member(s) | 6569 Guest(s)
Avatar

>