Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-1209 Push button alingment
#1

I noticed that when I align the push buttons on the 46-1209, the signals are not as strong as when tuning the same station using the dial tuning.

Is this normal?

Thanks,
Wayne
#2

I am not familiar with the 46-1209, but it is common that antique radio push buttons are not always the most accurate way to tune in a station. Many of the mechanisms were a little sloppy, and age doesn't help.

The artist formerly known as Puhpow! 8)
#3

Something interesting is that the presets don't all have the same frequency range. The leftmost are meant for lower-band AM while the rightmost are meant to higher-band AM.

Technically you bypass part of the main tuning circuitery in favor of a set of secondary tuner circuits. Perhaps it has to do with your recap?

On my 47-1230 the stations that I get do tune in quite strong, but I am having the hardest time to find any stations. There isn't much AM reception anyway, everyone broadcast in FM.

Similarly to your problem, my FM tuner isn't as strong as my AM tuner... Icon_sad

-Mars
#4

Marsupial, interesting... I seem to get better reception on FM than on AM on my 47-1230. I dont get all the AM stations that other am radios get but the FM seems very good.
#5

Warren, I get better reception on FM, but not as loud. I know it has to do with some still un-recapped capacitors. I have not touched most of that stage yet.

-Mars
#6

With my 47-1230 I have good strong output on manual tuned AM and SW as soon as I turn radio on. The manually tuned FM tends to drift off station until radio has warmed up for about 10-15 minutes, then it stays stable, but at much lower volume than AM. Presets are louder than manual tuning. I receive all available stations, up and down the dial, on all three bands manually. As for my 40-180 and 39-35, All of my station presets sound much louder than manual tuning, I think because they can be individually fine tuned to almost perfect reception. Just wish the 47-1230 had a button or two for FM preset! Now my Zenith 8-S-563, the volume is the same whether tuned manually or with the push buttons.
#7

I too would like FM presets.

There is barely anything in AM nowadays here, but FM has lots of good strong stations. They even stopped broadcasting news reports, traffic reports and sports (hockey) on AM. Icon_sad all on FM talk radio now.

I really need just one FM preset.

-Mars




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM

[-]
Who's Online
There are currently 5032 online users. [Complete List]
» 4 Member(s) | 5028 Guest(s)
AvatarAvatarAvatarAvatar

>