Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

124A/ B interstage Hammond xfmrs
#1

Has anyone tried those in any radio using pushpull interstage which needs 4:1 ratio? These have 3:1.
I wonder if it resuls in some loss of power. Also size is smaller.

Had using it result in any negative effects?

Radios like 20, 111, possibly 95, 87.
#2

I used 124E in my sparton 1466 worked as good as the original.
#3

Mike, upon recommendation I too used a 124E on my Fada with P-P 45s. Worked dandy.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#4

I too consider them as the modern 'go to' option.
#5

OK ood to know, it too is 1:3 turn ratio (1:9) impedance.
Q1: Is there real advantage over A and B otions? "A" is 27 bucks vs "E" being 45 bucks.

Q2: is there some loss of power due to 1/4 of driving voltage loss? Or does it matter conidering it is a radio?
#6

Q1 for a am radio I doubt you would notice the difference.

Q2 If the radio has a lot of audio gain probably won't notice it if it doesn't it may lack volume on weak stations.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 5588 online users. [Complete List]
» 2 Member(s) | 5586 Guest(s)
AvatarAvatar

>