Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 60 Cabinet Suggestions
#1

Hi guys,

I just finished the electrical work on my Philco 60, and it is playing nicely. However, I'm torn as to what to do with the cabinet.

Looking at the wear pattern, it's clear that this was a well used and well loved set. I would hate to lose all of that character by completely stripping it. Still, the finish is tired and the sides show some cracking.

Any suggestions on what route to take?


Attached Files Image(s)
       
#2

If you like the way it is now, you can always clean it up, get all wax, etc off then put a clear coat over what is there. It will protect it and look nicer with the clear coat over it.
#3

Like Warren said, you can clear coat it. I've done several cabinets like that. I clean them with mineral spirits and a paper towel. Allow it to dry, then go over it with a tack cloth. After that, spray some clear lacquer and you'll be good to go.

The artist formerly known as Puhpow! 8)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM

[-]
Who's Online
There are currently 1982 online users. [Complete List]
» 2 Member(s) | 1980 Guest(s)
AvatarAvatar

>