Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
The Philco Safari was introduction in 1960 as the world's first transistorized battery power portable TV.
I'd seen a few of these over the years but always too expensive or in poor condition. Finally, I got an ebay email alert about this one with a BIN of only $80 and I pounced on it.
[Image: https://farm3.staticflickr.com/2935/1421...19ff_z.jpg]
The only minor issue was a detached handle that just needed to be screwed back on.
[Image: https://farm6.staticflickr.com/5193/1423...22ea_z.jpg]
The battery is long gone, but you can also run these directly off AC. The seller claimed it worked so after an inspection inside, I went for it.
[Image: https://farm6.staticflickr.com/5319/1421...e543_z.jpg] [Image: https://farm3.staticflickr.com/2927/1423...95bc_z.jpg]
Bingo! It really does work  The image is quite bright and difficult to photograph.
[Image: https://farm3.staticflickr.com/2921/1421...6582_z.jpg] [Image: https://farm6.staticflickr.com/5079/1402...2e89_z.jpg]
It's strange how the image appears larger the further away you are.
[Image: https://farm6.staticflickr.com/5320/1418...2984_z.jpg] [Image: https://farm6.staticflickr.com/5510/1423...f057_z.jpg]
Here it is after a bit of cleaning.
[Image: https://farm6.staticflickr.com/5076/1402...ee3f_z.jpg]
I don't think it will be my new 'daily driver', but it's a neat piece of history to own.
[Image: https://farm6.staticflickr.com/5581/1419...2d6d_z.jpg]
Posts: 2,573
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
way cool congrats 
Posts: 1,106
Threads: 88
Joined: Jun 2011
City: Tacoma
State, Province, Country: Washington
Watching from four feet away, the picture is supposed to pretty much cover the entire surface area of the front screen. It almost looks like yours is missing that front glass.
Posts: 13
Threads: 2
Joined: Feb 2014
City: Columbia, MO
Nice find and price Bob. That one's on my list, as well. Looks like it produces a nice pic. Like most vintage sets, that cleaned up real nice!
Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
Nope, the glass is there. The screen is wider than 4:3 format, so I don't really see how the image could cover it all unless the top and bottom get cut off ?
[Image: https://farm3.staticflickr.com/2931/1402...c66c_z.jpg]
Posts: 13
Threads: 2
Joined: Feb 2014
City: Columbia, MO
Yes, that is right. I have a buddy, fellow TV collector who has one mint- bought new by a family member. It looks like your pix. I don't think you should expect a 16x9 flat screen look, mirror or not. Pretty sure that wasn't even a consumer product concept in the late 50's. Only in the movie theater back then.
Posts: 5
Threads: 0
Joined: Jun 2014
City: Rodengo Saiano
amazing and cute little set!
Posts: 1,468
Threads: 97
Joined: Jul 2012
City: Poughkeepsie, N.Y.
No I have seen everything! Never saw that portable before. Really cool!
Posts: 479
Threads: 73
Joined: Mar 2012
City: Riverside, CA
I saw your YouTube video on this, great find Bob. And for $80- you can't go wrong.
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
WoW! I'd be looking to do a Recap job at least for long term reliability. Too bad there is little current progam material worth watching.
Posts: 289
Threads: 42
Joined: Jan 2014
City: Jeffersonville
State, Province, Country: PA
Posts: 811
Threads: 43
Joined: Dec 2008
City: Chicago, IL
Sure, I'll do a full recap someday. As for current programming, there aren't any more NTSC broadcasts so many vintage TV collectors setup their own low power transmitters. I hook mine up to a DVD player or YouTube and play whatever I like
Posts: 1,114
Threads: 14
Joined: Feb 2013
City: Irvington, NY
It is quite remarkable that most of these Safari's are still operating on all their original parts 55 years later.
I have one I bought a few years ago, and it still works fine, never having been repaired or restored. Even all the electrolytics are original. Perhaps because most of the circuitry runs on on low voltages, the condition of these caps is less critical. Other than the electrolytics, most of the other caps are disc ceramics not subject to deterioration. I plan on leaving mine as is until I see any degradation in performance.
Posts: 1,106
Threads: 88
Joined: Jun 2011
City: Tacoma
State, Province, Country: Washington
One primary thing would be that back when these sets were still in general use, there wasn't as much TV to watch and/or people didn't watch as much as they do now. Especially when they were out and about. People used to go camping and to the beach to do other things besides watch television, so these didn't get a lot of use back when they were still new-ish. Ergo, things like the CRT didn't get worn out before they got put into storage in the back of someone's closet or where ever. Worst thing was that folks didn't remove the batteries first.
Posts: 4,861
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
The main issue with early solid state devices is the small electrolytic caps drying out with age more so then leakage, this is something that is more dependent on how the device is stored then how much it is used. On occasion, especially with 1960s era solid state devices, you can end up with leakage between the elements, instability, and even tin whiskers causing shorts, though I haven't heard of that being a problem with these TVs as yet. The other killer, as Brenda mentioned, is battery leakage, but that goes for battery powered tube stuff as well.
Regards
Arran
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Zenith H725
|
| Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately.
More ...EdHolland — 10:18 AM |
|
Graphics for majestic 1050 dial glass.
|
| Murf;
I found this thread on the ARF, the first photo has a pretty good view of the dial glass.
Regards
ArranArran — 01:12 AM |
|
Zenith H725
|
| hello Ed,
how about that speacial tape used for ducting it's like foil or how about thin piece of
aluminum roof flash...radiorich — 12:19 AM |
|
Zenith H725
|
| Ed;
One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM |
|
Zenith H725
|
| I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM |
|
Zenith H725
|
| The PSU filter cap arrived today (thank you USPS!) so I will work on that later.
Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM |
|
Philco 610B oscillator wiring
|
| Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM |
|
The list of my radio & TV collection!
|
| Magical chords of forgotten melodies, old nostalgic music on an old radio... Saturday night blues on the Mid-Waves on an...RadioSvit — 12:20 PM |
|
Philco 42-345 Restoration/Repair
|
| Thank you MrFixr55 the issue with this radio is that the internal coil antenna is missing and there was a wire in its pl...osanders0311 — 11:34 AM |
|
Philco 610B oscillator wiring
|
| Regarding the oscillator circuit which is comprised of the 6A7's cathode, control grid, and screen grid. These elements ...Radioroslyn — 10:33 AM |
|
Who's Online
|
There are currently 2492 online users. [Complete List]
» 1 Member(s) | 2491 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
