Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Brain Flatulant
#1

I know that I have seen this radio speaker table before. This one came with a RCA 103 speaker, flower embroidered grill cloth and all. Well, I am sure that is wrong, but with no tags or speaker I can't place the manufacture, but I am sure that I have seen the table before - so, what is it?

   

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#2

I can't say for sure, it may have been an aftermarket radio table and speaker cabinet, they used to market a lot of those back then. The top doesn't seem to match the base, it looks like someone either made it or added a top from another piece of furniture, though it could be be original. Since some used one of those horrible "Antiqued" finishes with the crappy green paint they may have added that top as well.
Regards
Arran
#3

No, they tried to fix the top and the original finish turned green - really.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#4

Van Dyke Walnut will turn green when it ages....
#5

So nobody remembers seeing one of these? I am trying to decide if I want to put the time into it, also find the proper speaker.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#6

I've seen a few speaker tables before, but none quite like yours.

Regarding the green finish, I once owned a Philco 296 radio/phono with an original finish that had turned greenish. My friend Doug Houston knew what caused it, and I remember him telling me, but I have since forgotten what he said.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently 1022 online users. [Complete List]
» 1 Member(s) | 1021 Guest(s)
Avatar

>