Posts: 236
Threads: 43
Joined: Oct 2010
City: Atlantic Highlands, NJ
Literally in parts, the cabinet is coming apart at the seams. All parts are there. The veneer is very good yet and with some glue I should be able to get it solid again. The cabinet is basically stripped eventually saving me time. Chassis is original and very clean underneath. A $25 CL find.
[Image: http://i1033.photobucket.com/albums/a414...e20fe8.jpg]
[Image: http://i1033.photobucket.com/albums/a414...eec17f.jpg]
[Image: http://i1033.photobucket.com/albums/a414...bdee63.jpg]
Steve
Posts: 15,444
Threads: 539
Joined: Oct 2011
City: Jackson, NJ
Stripped too. Had someone tried to start refinishing?
Posts: 4,639
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
Ah, a 38-116 in kit form. I didn't know that you could remove the control panel and top that way, very interesting. I have a G.E cabinet that has a curved control panel, though it does have a separate top, even though it had some screws holding it in it was very difficult to remove.
Regards
Arran
Posts: 236
Threads: 43
Joined: Oct 2010
City: Atlantic Highlands, NJ
The finish just peeled off over the years. I've seen others like that, the 116B's did that too.
Posts: 4,639
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
It may have been stored in somewhat less then a controlled environment, like an unheated garage, shed or basement. Not enough to make the veneer delaminate but enough to make the lacquer start to lift and flake off.
Regards
Arran
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
Nice set. Too bad about the cracked dial (or is it just the picture?) I think someone did strip or dunk the cabinet, but it should turn out very well.
Posts: 1,455
Threads: 96
Joined: Jul 2012
City: Poughkeepsie, N.Y.
And no grill bars.......Poor Great Philco!
Posts: 236
Threads: 43
Joined: Oct 2010
City: Atlantic Highlands, NJ
It has the grill bars too. They are off to the side. The glue dried out on them too and they just popped off nicely. It really is like a kit project.
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
Kit without instruction manual. Takes an expert! We'll be watching!
Posts: 120
Threads: 10
Joined: Jul 2011
City: Glendale, CA
That 38-116 looks like a pretty nice project. I hope you will post some more pictures as you go along. I'm glad it went to you rather than end up in some landfill.
Tom
Posts: 236
Threads: 43
Joined: Oct 2010
City: Atlantic Highlands, NJ
I will definitely post pictures but wont get to it until the winter as it stands now. I have too many home projects before the summer runs out!
Steve