Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 1926
#1

Hello everybody,

Newbie to the forum here. I hope I am posting this in the right forum.

Today, I saw a Canadian made Philco Model 1926 for sale. It is a large one-piece cabinet housing the speakers, and under a lift-up lid, a record player and a radio. The unit seemed to be in good condition, but I did not have the time today to check it thoroughly. Assuming that everything is in working condition upon further inspection, what would be an approximate value for this?

Thanks in advance to everyone that is able to assist.
#2

Hi QCubed,

Not being familiar with the model in question, I can only say this: Most console stereos have little to no value to a radio collector. Now, if the unit has the tapered legs set at an angle as is common with many pieces of furniture associated with Mid Century Modernism, then you could potentially sell it for up to $200 or more to a MCM enthusiast. But if it has no legs and sits right on the floor, then the value drops back to near zero.

--
Ron Ramirez
Ferdinand IN
#3

Hi Ron,

Thanks for your help! I will check it out more thoroughly. The cabinet definitely had those tapering legs. This unit has a record player in it so it can't be very old, though, judging by its styling I am going to guess that it was built in late 60s or early 70s.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently 3907 online users. [Complete List]
» 1 Member(s) | 3906 Guest(s)
Avatar

>