Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Atwater Kent 40
#1

It was so nice and clean I couldn't resist. Found in a local antique mall. The E series speaker was there also and tested good, but they wanted $195.00 for the speaker by itself so I passed on that. 

[Image: http://i1319.photobucket.com/albums/t679...d840d9.jpg]
[Image: http://i1319.photobucket.com/albums/t679...11e547.jpg]

[Image: http://i1319.photobucket.com/albums/t679...f36b73.jpg]
[Image: http://i1319.photobucket.com/albums/t679...7d4481.jpg]
#2

The green resistor was added, and I think it is the wrong value cause' one is 12500 and the other is 65000.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#3

 I would wait a few months and go back and make an offer, the boobs pretty much blew their best chance of selling that cone speaker when they sold you the radio without it, it's unlikely that anyone would hand over $195 for something that is now basically useless for anything other than an ornament. Those speakers turn up with great regularity on fleabay for less then half that, to say nothing of swap meets.
Regards
Arran
#4

Arran, that's sorta my line of thinking as well. They also had a Radiola 18, asking price $95. It was missing the dial lamp hood, the back, and the dial would not turn. It had an Atwater Kent horn speaker with it, model M I believe. The radios and speakers were individually priced. They were asking quite a bit for it too. Do not remember exactly how much...but too much. I had taken a 9v battery with me to test any speakers I ran across. The horn was dead, the AK E series tested good. It was in as good of shape as the radio, so in a few months I'll go back and see if I can make a deal. If not, there are plenty of others as you said.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6970 online users. [Complete List]
» 1 Member(s) | 6969 Guest(s)
Avatar

>