Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 610 Cabinet Color
#1

I picked up a Model 610 at the NJARC flea market this weekend and the case is in very good shape. Looking at pictures on the web I can not tell if the case is a single color, a medium brown on the one I have, or are the sides a darker color than the front panel. The lighting on web pictures can sometimes be decieving. Thanks.

Harv

Harv
#2

Hi

The center part of the 610B front panel is Medium Walnut. The rest of the front panel, as well as the remainder of the cabinet, should be a slightly darker shade; such as Perfect Brown or Medium Dark Walnut.

Most people (incorrectly) refinish these cabinets in a single color...yes, including the one on my site's Gallery.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron. I like the two tone look better, as shown in the Model 60 I restored, but wanted to make the 610 case as accurate as possible to its original state.

Harv




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 4054 online users. [Complete List]
» 2 Member(s) | 4052 Guest(s)
AvatarAvatar

>