1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
41-610 121 light string gudie for the bands
Jeffb1960
Junior Member
**
Posts: 6
Threads: 1
Joined: Feb 2015
City: Gulfport, MS
#16

02-15-2015, 11:50 AM
mine had a spring and thank you again
Find
K7Sparky
Member
***
Posts: 61
Threads: 5
Joined: Mar 2014
City: Holiday TN
#17

02-23-2015, 08:47 PM
You are correct Ron, There is a spring.

The dial cord on the light is also heavier than the regular tuning pointer.

I finally found a metalized cord that holds to the light OK.  It just fits under the tab in the light.  The light slides on regular dial cord.  I still have the original broken cord in the picture and can mike it if you need the diameter.

If you need a bit of what I used PM me with the length you need, I can measure the broken cord that came off my 41-280 or say a foot and your snail mail.  You can donate what ever you think it's worth & the postage to the forum when you get it.

[Image: http://i1356.photobucket.com/albums/q734...90964f.jpg]
Taken as restoration started

Don't have a picture after the replacement
(This post was last modified: 02-23-2015, 08:54 PM by K7Sparky.)
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration