Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Big Fisher speakers ?
#16

Well...

"Digital Compatible" - lots of companies producing audio equipment were putting that or similar labeling on their gear after CDs first came out.
"Magnetic Field Compensated" - don't know how they could do that, unless they put a big Faraday cage inside the cabinet. Which I highly doubt.
The frequency response pattern - Probably accurate. If it weren't, I would think they would have run afoul of the FTC or some other alphabet soup gubmint agency.

When Avery Fisher owned Fisher Radio, it was a respected outfit that produced quality equipment.

After Avery sold out to Emerson, the quality started going downhill. Emerson retained Fisher's team of German engineers to design the receivers, but I am sure they also had their bean counters breathing down the necks of those engineers.

After Emerson sold the Fisher brand to Sanyo, the brand really went downhill from there. They finally faded into the history books.

By the time your speakers were built, Sanyo had owned Fisher for several years. I'm not saying your speakers are no good. Let's just say Fisher was, ah, past their prime by then.

--
Ron Ramirez
Ferdinand IN
#17

You see that 6 - 8db bump at 50hz? Kind of like mountains as seen from space. Make the graph small enough and it looks flat.

5db is about 3X the level up from 0. You can hear that, but they wanted you to. Sounded impressive and powerful in the showroom.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently no members online.

>