Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 95
#1

Hi Guy's,
Posted a thread before about a model 95 I brought home last week.
Aaron was correct about the cabinet being refinished. After looking it over closely and comparing to an original 95, I can see it now.
Probably won't refinish it though as I am going to sell it anyway.
The radio plays perfectly, but of course I had to remove the chassis and the bottom cover plate just to see if it has ever been re-capped.
Kind of a strange layout as compared to what I usually work on.
Appears to be unmolested.
Caps are held in with brackets or clips and some are wired to the side of the cap.
Resistors all appear to be original.
I am amazed that this still plays like a new radio with as old as it is.
Looking at Nostalgia radio schematics, I do not see a parts list.
Don't see that the caps are marked either.
One page of the schematics does show part ID numbers on the caps.
Anyone have a parts list for this radio?
murf
#2

http://www.philcoradio.com/tech/images/95.jpg
Note a few of the caps have resistors molded in with cap. Easiest way to repair is to cut the gnd lead off and solder new cap under the old one.
Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM

[-]
Who's Online
There are currently 232 online users. [Complete List]
» 1 Member(s) | 231 Guest(s)
Avatar

>