Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

pre war chairside/Finished/almost
#1

Heres another , a very nice GE chair side, the sound on this very nice , yes it plays but will go thru it for performance and safety. Very nice looking with those sliding doors and book matched veneer on top and phono cover slides and hides with the booked veneer . Slide rule dial, AM and 2 short wave bands, storage area in back for your albums or mags. Very nice pre war set Icon_eek Icon_eek Icon_eek


Attached Files Image(s)
               
#2

Up date on cabinet, grain filled and toned and cleared, will complete when electrical is done including turntable, this radio has a light on bottom front of cabinet which is pretty cool. The bulb , socket and wiring is there but no lens. I call those cat eyes, like the reflector nuts for old bicycle license plates. The hole is there ,its 3/4 hole for cat eye, if any of you have one to sell let me know. It suppose to come on when set is turned on, theres a name for that light , I don't know what it is. May be to let you now the power is on? 


Attached Files Image(s)
               
#3

Ok got this far and this does not look like the same radio 2 weeks ago, the sound is amazing coming from this 7 tube radio, 12 inch speaker Icon_eek Someone will be happy when they purchase this because I have no more room to keep any radios, I do have more room but I will not allow my self to do so, I have seen hoarder shows and do not want to get anything near that. Icon_clap


Attached Files Image(s)
                   
#4

A few more Icon_eek Icon_eek Icon_eek


Attached Files Image(s)
           
#5

Very nice. How did you deal with the roll top doors?

Charlie in San Antonio
#6

(07-23-2015, 06:02 PM)ccomer1955 Wrote:  Very nice. How did you deal with the roll top doors?

I left the doors on, cleaned and used spray toner by mowhawk.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 4007 online users. [Complete List]
» 1 Member(s) | 4006 Guest(s)
Avatar

>