Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 39-40XX
#1

Is the 39-40 a decent performer? Have the chance to buy one for $20 that a guy wants out of his garage. It doesnt work but it is complete and in good shape. If something is serious wrong with it and I cant get it to work I figure all the parts are worth the $20. But if I did get it to work, is it compairable to my 40-180? I see that it uses #42 output tubes instead of #41 tubes like my 40-180. Stronger output circuits? Any thoughts?
#2

Yah, an above average performer...well worth $20...you haven't bought it yet? Icon_wink

--
Ron Ramirez
Ferdinand IN
#3

Kind of a bummer this morning. Contacted the guy and set up a time and place to buy it and then posted this question on the phorum. Then I got a text message about a half hour later saying that his wife had already sold it to someone earlier in the morning and didn't tell him about it. Kind of ruined my morning. I don't think the cabinet would have even needed to be refinished, it was that nice!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 3986 online users. [Complete List]
» 2 Member(s) | 3984 Guest(s)
AvatarAvatar

>