'42 BOL Drive Wheel

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode

'42 BOL Drive Wheel

davidff
Member

Posts: 83
Threads: 30
Joined: Aug 2011
City: SOUTHINGTON, CT

08-12-2014, 08:52 AM

I recently disassembled the "bell drive" on this challenging changer, and sent the drive wheel out for a rebuild. The vendor is asking if Philco has the exact diameter of the rubber at the bottom of the wheel, as well as the tire at the top. Both ends of mine are in bad shape and the changer manual does not seem to show the dimensions. Any help is appreciated as I know some of you have rebuilt these changers in the past.

Find

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM
38-10T chassis Restoration begins
I have a question about the mica sheets. I thought I saw somewhere on the Phorum where someone used thin plastic report ...dconant — 10:44 AM
38-10T chassis Restoration begins
Yes, you should carefully remove the mica sheets from the trimmers otherwise you risk trapping foreign material in the t...RodB — 10:34 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me