Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fisher X-101-D or Eico ST 70
#1

So I need your opinion on which one should I keep. Both have 7591 output tubes but the Fisher I believe has a built in multiplex, correct me if I'm wrong. I will provide pictures soon, having some issues with photobucket.
#2

pictures i hope ! of the Fisher[Image: http://i1281.photobucket.com/albums/a508...jgzw4j.jpg]
[Image: http://i1281.photobucket.com/albums/a508...wcxbde.jpg]
#3

And pictures of the Eico that i have already finished the rebuild, and it sounds fantastic. So someone tell me will the Fisher perform better.[Image: http://i1281.photobucket.com/albums/a508...lhiqjb.jpg]
[Image: http://i1281.photobucket.com/albums/a508...sqaybd.jpg]
#4

I've had both and I'd keep the Fisher. No multiplex in the Fisher as a MPX is used in a tuner or receiver. The X-101-D does have a strange bias set up but it's a great sounding amplifier.
#5

You'd probably get more $ for the Fisher (if both restored,) but probably not a whole lot of difference otherwise.
#6

Well i tried to sell the Fisher and no takers, so i'm keeping it and selling the Eico. The Eico is restored and the Fisher is not but i will remedy that real soon. Thanks everyone for the input and suggestions.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM

[-]
Who's Online
There are currently 1224 online users. [Complete List]
» 3 Member(s) | 1221 Guest(s)
AvatarAvatarAvatar

>