Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

ID this Bracket on Philco 16B chassis
#1

Can't figure what it was used for.
Original to this chassis.

Bob T


Attached Files Image(s)
   
#2

The bracket does not belong there. Someone added it for who knows what.

Steve

M R Radios   C M Tubes
#3

+1 what Steve said.

--
Ron Ramirez
Ferdinand IN
#4

I think it was used tohold an antenna maybe.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#5

Like they said.
Definitely not factory original.  Dealer or owner add-on.
#6

Attached to the other side of this bracket is the Wave Trap Assembly (PHOTO)

Inductive Wave Trap with Compensating Assembly

Items 3 and 4 on Parts list

It is covered with a soft crystal looking material. Do not know what that is

Will clean later and see if coil still good.


Bob T

The Crystal Material looks like the goo when a Battery leaks.
Just had one yesterday AAA Battery leaked and looked the same.


Attached Files Image(s)
   
#7

I believe that Bracket was added.
Its use was to hang the Antenna Wire on

I saw another one , not same Bracket , but had about 20 feet of wire wrapped and hung on the bracket.

So I stand by my answer and that is all there is to it.

No don't try to change my mind, it is made up.



Any other ideas Icon_crazy 

Bob T




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM
RCA WV-98c
If I had it in front of me, I would triy to trace the signal on one of the non-working functions. Try to trace and high...morzh — 08:21 PM

[-]
Who's Online
There are currently 1231 online users. [Complete List]
» 1 Member(s) | 1230 Guest(s)
Avatar

>