Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Whatzit on 42-1010
#1

On my 42-1010 console, there is a small black cast metal box mounted to the cabinet next the the chassis. The harness to the beam of light pickup connects to this box with a 4-pin plug, and there is an RCA jack on the box as well. What purpose does this box serve and what's inside?
#2

Phono Input Transformer, Part No. 89 on the schematic.
#3

Chuck Schwark Wrote:Phono Input Transformer, Part No. 89 on the schematic.

Which would explain why I had no audio from the phono until I reconnected it. Audio levels came up a bit with the contacks cleaned, but I'm betting that the cell is pretty much shot as I just can't get much volume without turning the volume knob up at least 3/4 of the way. Not a big thing until I forget and switch to radio and blast the furniture across the room!

Once I get the dial restrung and get the chassis back in the cabinet, I'll tackle replacing the cell.
#4

The link to Don Cochrane on my BOL page. Don rebuilds these BOL cells.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6318 online users. [Complete List]
» 4 Member(s) | 6314 Guest(s)
AvatarAvatarAvatarAvatar

>