Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Tropic A-3601 Info
#1

Hey all,
I have a nice looking 1955 Philco Tropic A-3601 that's worth restoring. It was built in the UK, but the power supply is engineered for USA mains. It appears to be similar to an AA5 set, with the addition of a shortwave band. All the tubes are common types and UK made. I slowly powered it up and it worked fairly well, but all the tubes test weak and need to be replaced. I'd like to locate a schematic, or at least some alignment info, as I'm not sure what the IF frequency is. My usual sources came up dry.
#2

The best I could find was this from another board
http://www.vintage-radio.net/forum/showt...p?p=678749

They seem to think it's similar to the A-3606 and there's a schematic available for that from here
http://www.service-data.com/section.php/5566/1/a3606

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#3

Wait till Ron answers. He's pretty fond of Tropics so might possibly have something.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

The A3601 schematic isn't in my copy of the UK Vintage Radio Service Data DVD, which (unfortunately) is typical of UK-made Philco Tropic sets.

That DVD was sold by the same forum WallaceRoger Greg referenced above.

--
Ron Ramirez
Ferdinand IN
#5

Thanks for looking Ron. I'll take Greg's advice and see if I can work with the A-3606.
#6

If anyone's still following this thread, I recently got back to this radio, as I was waiting for a repro dial from Radio Daze. It looks great, so now I'm trying to finish up the calibration. However, the A-3606 data is not helpful. I really need the the A-3601 info or an equivalent US model. Any clues?




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 5117 online users. [Complete List]
» 4 Member(s) | 5113 Guest(s)
AvatarAvatarAvatarAvatar

>