Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Unknown Chassis - Found!!
#1

Customer sent this to me and claimed it was a 41-260, but it is not. Cannot even read most of the tubes. Can someone ID it?

Thank you,


Attached Files Image(s)
   
#2

How about a 41-255T  or possibly a 41-256T.

update: NOPE...I think its a 41-250T....only 8 tubes.
#3

Bob,
Thx, but wrong tube layout.
#4

I'm voting for 41-280 But there where a number of set that are vary similar from 40-42. Going from right to left tubes are XXL, XXL, 7B7, 7B7, 7C6, 41, 41, 84.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Regardless of actual model..............looks to be a job! How does it look underneath?

Will take some hours at that one.

Good luck. Icon_smile Icon_smile

Paul

Tubetalk1
#6

Terry found it! It is a 41-280.

Thank you,
#7

Paul, Clean underneath




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 6048 online users. [Complete List]
» 2 Member(s) | 6046 Guest(s)
AvatarAvatar

>