Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Jackson 641-A signal generator
#1

I just bought this on eBay. It should be useful aligning FM receivers like the Philco 48-482, which I had to do using the old method outlined in the service instructions, but was not the preferred method.
[Image: https://66.media.tumblr.com/6619687a567a...1_1280.jpg]
#2

By the way, does anybody have the manual for it, or know where I can get a copy? A clear PDF would be fine, or even a series of clear JPGs.
#3

I found a place where one can order the manua; for this signal generator. They also carry manuals for a LOT of other equipment, and are a resource you may want to add to your list of bookmarks as I did. https://manualman.com/index.cfm?v_link=main   By the way, they take PayPal as well as checks for payment. I'm glad, because PayPal is my preferred method for online buying.
#4

Congrats. I've heard and read that Jackson made some good test equipment. I've never owned any, though, so I can't speak from experience.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Hi Bridcarl +1 on the others.  Pin 6 of the 7C6 is the AVC Diode so it is appropriate that that pin 4 of the coil con...MrFixr55 — 07:30 AM
462ron
Joseph, this is beyond awesome. A lot of thought and engineering went into this and you hit a home run! Now I must save ...462ron — 07:27 AM
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM

[-]
Who's Online
There are currently 3331 online users. [Complete List]
» 1 Member(s) | 3330 Guest(s)
Avatar

>