Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA model 211K parts list needed
#1

Anyone have a parts list for an RCA model 211k?
I only see 3 filter caps on the schematics and the can mounted on the chassis lists 4.
Values are a little different on the can, so I am guessing this can was replaced at some point?
Does not hum when played, so maybe I can leave the filter caps alone?
murf
#2

https://worldradiohistory.com/ARCHIVE-RC...1942-C.pdf

look at page 782-C (page 799 of the PDF) The RCA schematic, very clear, is just before it, as is the alignment information, etc.
#3

Never mind guy's,
No parts list available for this model.
Just have to get it off the schematic I guess.
Sorry.
murf
#4

> No parts list available for this model.

Yes, there is - Mike gave you the answer (post #2, above).

--
Ron Ramirez
Ferdinand IN
#5

Had a hard time with the link Mike sent, so I just worked off the schematic.
Thanks for Mikes time spent looking that up.
murf
#6

Murf, are you familiar with using PDFs? That link takes you to volume C of the RCA information. What you want, the parts list is on page 799 of the PDF. Just enter that in the little window at the top of the viewer where the page numbers show up, and hit enter. The PDF is a rather long file, so it won't load completely right at once, but will take several minutes, depending on your download speed. There is a lot of other useful information there, so I hope you figure out how to use PDFs with your browser. Of course, it does work best with a regular desktop of laptop with a full screen rather than trying to use a telephone or tablet.
The home site from which that information comes is: https://worldradiohistory.com/index.htm
The RCA service information is found on the files here:
https://worldradiohistory.com/RCA-Victor-Service.htm
I hope you can master how to download and use the PDFs available from this site. They really are a valuable resource, not just for RCA service information, but for radio in general.
#7

Got it Mike.
Thanks for the info.
murf




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM

[-]
Who's Online
There are currently 1259 online users. [Complete List]
» 3 Member(s) | 1256 Guest(s)
AvatarAvatarAvatar

>