Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 316 schematic needed
#1

I recently received a Philco 316 code 126 radio. It was manufactured in Toronto so it’s a Canadian model. I did find one schematic on Nostalgia Air but it’s very fuzzy and hard to make out the values for the caps and resistors. It also doesn't contain a parts list which I find very helpful since I’m relatively new to this hobby.

Does anyone have a better copy of this schematic or possibly a parts list that they could post, or is there a US model that is the same as the Canadian model?

Appreciate any assistance.
#2

If it's the set I think it is the U.S model is a model 16, but then again there is typically a Code number as well as a model number. The 316 should be in the RCC manuals, which I think the radiocodegods site has, I don't think Pacifictv has Philco models, here are some better diagrams of the U.S versions on this site https://philcoradio.com/library/index.ph...ams-vol-1/

Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 610B oscillator wiring
Thanks for the replies. It's not the really the hum that I am after. Just trying to understand why only the shortwave ba...Tubester — 04:01 PM
Restoring Philco 96
70 and 90 are Superhets, but at least the 2x45 model of 90 uses the Plate detector (and so does 70). Also the Atwaters,...morzh — 03:28 PM
Restoring Philco 96
Morzh, Prayers for your mom. I am sure that there was enough pain living through the Holocaust as a child. I pray dail...MrFixr55 — 02:19 PM
Philco 610B oscillator wiring
Hi Dan, Divide and conquer. First off trry to differentiate between 60Hz and 120 Hz hum. 120 Hz hum has a higher pit...MrFixr55 — 01:49 PM
Restoring Philco 96
Yes, other than takin a toll on your back, they are undeed way more repair friendly than many other Philcos. To me, som...morzh — 01:04 PM
Philco 610B oscillator wiring
If the wires look like they were this way from the factory (very neat and very dull soldering joints), I'd leave them be...morzh — 12:58 PM
My Philco 37-116 Restore
I managed to open up the Expander Unit and replace the grid cap wires. Tested the connections found they looked good and...dconant — 12:19 PM
610B Oscillator Questions
I've included a picture of the 'actual' schematic I created. I double checked several times and it appears to be accur...Tubester — 09:26 AM
First Radio restoration
Hi, welcome. I did a 40-130 a few years ago. I was very surprised at how well it performed. Just take care with that sp...Stan the Man — 07:20 AM
Restoring Philco 96
Situations of the like are not pleasant. Life is inevitable. Best of luck to you. I have two 76 chassis, in different ...Stan the Man — 07:12 AM

[-]
Who's Online
There are currently 1930 online users. [Complete List]
» 3 Member(s) | 1927 Guest(s)
AvatarAvatarAvatar

>