Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 111 oddity
#1

I just got back the guts for my Philco 111 today and besides needing all new capacitors, resistors, speaker cone, a volume control, output transformer, and the tone control rebuilt, it had one head scratching oddity. The guy who redid it for me found a 750 ohm resistor in the tuning circuit in a spot that calls for a 1300 ohm resistor. This looked like a very old repair because the solder looked about as old as the rest of the components under the chassis. When he tested te radio, it would not work! In no way would it work with that 750 ohm resistor in there! Now here is the question: How many years has this radio sat silent because of a bad repair? It is very possible that this radio has sat nearly 70 years silent. A good head scratcher indeed. Icon_confused

No matter where you go, there you are.
#2

Yes, it's possible. There were guys back then that did not know what they were doing underneath a radio chassis, just like there are today.

At least the problem with yours was found, and I trust it plays like new now?

--
Ron Ramirez
Ferdinand IN
#3

Mine seems to be playing fine, though I could swear it had clearer tone sitting on the workbench than it now does in the cabinet. Could be my ears though, got a cold that is now also in my chest and it is making my ears stuffy.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5101 online users. [Complete List]
» 1 Member(s) | 5100 Guest(s)
Avatar

>