Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 2 different grill cloths?
#1

Working on a 37-116 and I noticed that it had a different pattern of cloth behind the small cutouts. The cloth all looks old and I'm wondering if this is an old repair or was it made this way?

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.

John
Las Vegas, NV USA
#2

It's an old repair, because neither pattern is correct.

It should have the 1935-37 "V" pattern cloth in all three openings:
[Image: http://i326.photobucket.com/albums/k420/..._cloth.jpg]

Of course, now that this pattern is no longer being reproduced, unless/until someone else begins to reproduce the cloth again, we have to make do as best we can, just like we did before reproduction grille cloth became available.

--
Ron Ramirez
Ferdinand IN
#3

I knew I should have bought more of the V pattern when it was available. My 116 will have to wait now. Icon_sad

Steve Chambers
#4

I think I'm gonna cry. A 5' by 7'8" hunk of the cloth went on ebay last month for $260.50

http://cgi.ebay.com/280742240172

Icon_cry Icon_cry Icon_cry Icon_cry Icon_cry

John
Las Vegas, NV USA
#5

Lets not get nuts about cloth. As long as it is somewhat acousically tansparent and hue and value somewhat match the cabinet you have done well.
#6

That cloth looks like it came from an RCA radio, not correct but it doesn't look bad. I wouldn't panic about the grille cloth, it will go back into production eventually and then the party that paid $260 for a bolt of the Philco chevron cloth will be kicking themselves.
Regards
Arran




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 7047 online users. [Complete List]
» 2 Member(s) | 7045 Guest(s)
AvatarAvatar

>