Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 95 Main Power X-Former needed
#1

I'm trying to repair a Philco 95 Lowboy (1929?) and after frying the Dual Bias resistor near the 80 tube, I've determined that I have some x-former issues, as I have ~325 on one tap but only ~150 on the other. I show approx 150 ohms to ground, so it looks like I have a few shorts to ground as well as to other windings in the main transformer. Can anyone recommend where to find a replacement? I'd prefer to keep it original as I still have the original speaker cloth and everything else has been updated, so multiple x-formers and modern rectifiers are a last resort only.
Thank you in advance for any and all help!

FB#9
#2

Pull the part number off the transformer (or service info) and see if Play Things of Past has one:

http://www.oldradioparts.com

Other alternative is another 95 junker chassis.
#3

If you don't need to be strictly authentic, a power transformer from Models 96, 111 or 112 will also work. They all look alike topside; the connections underneath differ from the 95 transformer, however.

Please do follow Chuck's advice re: checking with Play Things Of Past. This would be the easiest way for you to find a replacement.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4669 online users. [Complete List]
» 3 Member(s) | 4666 Guest(s)
AvatarAvatarAvatar

>