Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Transitone for a 1936 Packard 12
#1

Hi all - I'm in the middle of restoring a Philco PA 3833, 1421P for a 1936 Packard also being restored. This is unique radio with the detached head assembly with control cables between the head and unit. The restoration is pretty much streight forward, some chrome to be redone and the case blasted and painted. It has a detached speaker, 8" round. I have two of these units so I should have any parts that I may need. The one problem I have and have had it before, were do you find the proper grill cloth for it. In the past I've gotten close but this time the car is worth about $250K and I sure would like to have the right stuff. I have the old cloth but due to it's age it is hard to tell a lot, you can pick up the design but the colors are a guess. Any ideas?
#2

Try asking John O. at http://www.grillecloth.com
#3

I have looked at all their samples on line, but I'll try contacting him.

Thanks,




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM

[-]
Who's Online
There are currently 1710 online users. [Complete List]
» 1 Member(s) | 1709 Guest(s)
Avatar

>