Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Just got afew new consoles
#1

http://www.flickr.com/photos/53710524@N0...hotostream

Much tnx to Rockeeter for making this possible and for saving all the little bits and pieces from one junk set. This made it possible for me to build up a 116X from his spares and a $10 cabinet I picked up today from Epay. Now I have two!!
Now for the fun after I get the Packard car radio done(just about ready to give it back to the owner) I can start on one of these puppies!! Or one of a few hundred projects.
Terry
#2

Good going, Terry!

Will you be going to Kutztown in a few weeks?

--
Ron Ramirez
Ferdinand IN
#3

Not sure. Work on Saturdays and Sunday can be a little tough to get away. Awhile back I picked up a 650 that is pretty rough but I think I can salvage enough of the grill cloth (it's pretty rough too) from it the repair the torn pieces over the two clairfiers on one of the sets.
Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 3621 online users. [Complete List]
» 2 Member(s) | 3619 Guest(s)
AvatarAvatar

>