Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 19 cabinet
#1

Hi everyone,

I am about to restore a Philco 19 cathedral cabinet. From the pictures I've viewed in books and on the web, it seems that some of the references show the inside front as darker, almost dark walnut, contrasting to a lighter outside front and sides. Other show it as one shade. Mine looks to be original finish, and the same tone.

Where there variations for this model?

Thanks, Pat
#2

The ones I have seen that were in very good shape appear to have the equivalent of Medium Walnut on the body of the cabinet, with just enough Extra Dark Walnut on the front panel to give a two-tone contrast without going overboard. This seems to be true of all 1932-34 Philcos of that particular style, with the inset front panel.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM
RCA WV-98c
If I had it in front of me, I would triy to trace the signal on one of the non-working functions. Try to trace and high...morzh — 08:21 PM

[-]
Who's Online
There are currently 1228 online users. [Complete List]
» 1 Member(s) | 1227 Guest(s)
Avatar

>