Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

640 and 650 band indicator masks
#1

Do the 4-band 640 and 650 Philcos have a dial mask that moves behind the dial to show which band it is on? It doesn't seem to be present in two 650's and one 640 in my collection; oddly enough, the 3-band 645 DOES have this mask, changing the brilliance of the indicating "Y".

I just bought a junker 650 with the idea of transplanting this mask- but the junker doesn't have one either. At least I now have a cabinet for the 640 chassis that's been collecting dust.

Pete AI2V
#2

Just went downstairs and checked my 650B plus a 650RX chassis I have in the archives; neither have the shadow mask.

Apparently this idea was not fully implemented throughout most of the Philco lineup until mid-season 1936. Models 116 and 660 had shadow masks in the first half of the season, while Models 650, 643, 640, 630, 623, 620, 611 & 610 did not.

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron.

I won't be looking for something that doesn't exist any more.

Pete AI2V




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5433 online users. [Complete List]
» 1 Member(s) | 5432 Guest(s)
Avatar

>