Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-216, 41-316 and similar sets - WHAT'S WITH THE HOLE?
#1

I recently acquired a Philco 40-216 with remote control. The cabinet has a hole about 3/8" in diameter in the center of the cabinet right below the fold-up cover. I looked at other similar sets such as a 39-45, 41-316, and 39-116 in various galleries and they ALL seem to have the same hole. It looks like something is MISSING. But WHAT? And why do ALL sets I have seen have this hole?

Does anyone know what might be missing and have a photo?

Thanks
#2

Very simply, a pilot light. There was a plastic jewel that went in there. I use to have a 42-1015. I used to be able to get red jewels from when I was in the vending business years ago. It was for a "use coin only" light. I used the little piece from the top of a red Bic pen in some cases now. It's not transparent like the originals but works. The originals disintegrated and turned to powder which is why they are always missing.




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>