1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Television
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
49-1450 Safety Glass
Guest
Unregistered
 
#1

06-20-2010, 06:21 PM
I have just acquired this Philco 49-1450. Does anyone know how to remove the front wood framed safety glass for cleaning. It looks very easy but I don't want to break anything. Thank You.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
Big Dave
Member
***
Posts: 51
Threads: 9
Joined: Oct 2005
City: Warren, OH
#2

06-20-2010, 08:55 PM
I have access to one I can look at. I think a couple of screws are removed and the frame tilts off.
Visit the world's worst TV restoration website.

http://evilfurnaceman.tripod.com
Website Find
Guest
Unregistered
 
#3

06-21-2010, 10:32 AM
You're right! I found the two screws and the wood fame slid off nicely. Thank You so Much! C Felton
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3795 online users. [Complete List]
» 3 Member(s) | 3792 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Television