Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I've been poaching 660L
#16

Just out of curiosity I compared the schematic of the 118 to the model 18, the circuit shows that the plate and screen of the #42 driver tube are connected together, with a .006 uf cap going to ground. Other then the frequency coverage the 18 and the 118 are very similar sets, how the drafting errors escaped proofreading I have no idea.
Regards
Arran
#17

I thought it was Philco season... Or maybe it's rabbit or duck season... Icon_biggrin
#18

Triode or not, I love that stealth form factor. Nice score. I bet lots of spouses - notice I didn't say "wives" - who disapprove of decorating with old radios would "allow" that beauty in a room.
#19

Back in 1936 Philco produced two sets, the 660L and the 650H which where called the "All Period" sets. Designed to go with any room furniture style expect for Modern. The sets are similar in style. Today it might be called the Edsel.
Terry
#20

Why Edsel? That car was the joke of the auto industry for decades.
#21

It was meant to please everyone but pleased no one.
Terry




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 4083 online users. [Complete List]
» 2 Member(s) | 4081 Guest(s)
AvatarAvatar

>