Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1951 Philco TV remote control?
#1

1951 Philco TV remote control?

I'm preparing a PowerPoint lecture and want to mention remote control technology for TVs.

An old post on ARF mentions a wired remote control for a Philco 51-T2176 television.

Supposed to have a spring loaded wire reel with pendant switch head.

Are there any advertisements or service literature showing the mechanism? All I've found is one picture of a chassis but it of such low resolution as to be useless for my needs.

Thanks,
Robert
#2

Here's an ad with a remote on it.  Not realhigh res though. Click on the 192k image.

https://www.tvhistory.tv/1951%20Advertising.htm
#3

Thanks for the link. I don't know why, but when I went to Google Images for my Philco search, it was not there but when I searched again later, there it was...

That will fill the bill for now...

All the best,
Robert
#4

The ETF has a scan of the Sams Photofact for this set that contains service info and photos of the remote mechanism.  Start on page 27 (PDF page 26).

Philco 51-T2176 Sams Photofact 132-10

Sean
WØKPX
#5

Great! - Did not know TV Sams were out there...




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently no members online.

>