Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

unknown philoco
#1

i recently purchased a philco at a yard sale. i have searched the internet. can't find on even similar to it. can anyone tell me where to find a model #. it has a part # 10718
#2

Hi

Cabinet part no. 10718 corresponds to a 1949 Philco radio-phonograph, model 49-1602.

http://www.philcoradio.com/gallery/1949.htm#z

If this does not match your set, then please provide photos and we'll try again to identify it.

--
Ron Ramirez
Ferdinand IN
#3

hi, that is it thank you. was there a record adapter for 45 rmp included with this. if how can i find one?
#4

According to Philco documentation, the original record changer in the 49-1602 was 78 rpm only. If it has a three speed changer, it is not the original unit.

Look and see if there is a name anywhere on the changer. Then contact these folks, they may have a 45 rpm adapter if this is indeed a three or four speed changer in your Philco:

http://www.west-techservices.com/

--
Ron Ramirez
Ferdinand IN
#5

thank you for the info. i noticed after looking at several pictures that the phonograph is not the original one that came with it. i greatly appreciate all your help. do you have any suggestions as to were i can find the original. thank you
#6

i found one on the internet in Memphis. the person who has it said it is in really rough shape. it is pretty rust. how can i send you a picture. do you have any suggestions on restoration. thank you




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 4100 online users. [Complete List]
» 1 Member(s) | 4099 Guest(s)
Avatar

>