Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pushbutton on/off switch 41-231
#1

I saw the thread about refurbishing the 41-231 switch:
http://philcoradio.com/phorum/showthread...ght=41-231
I am wondering if anyone has a source for an original switch and/or push-button.
I bought a pretty little 41-231 which is close to perfect but the last owner discarded the original switch. I now have no button or switch.
Anyone know of a source or have a spare they would be willing to sell?
Thanks
qanerd
#2

Are you saying the entire pushbutton assembly is missing?

--
Ron Ramirez
Ferdinand IN
#3

Yes the switch has been replace by some klutz with a hardware store toggle switch. The rest of the radio is all there and I would like for this to be original. Looking for a switch to rebuild but especially with a button. I can figure out how to adapt a newer switch I think (I hope).
Thanks
#4

So you will be needing a pushbutton assembly from one of the following:

41-225
41-226
41-231
41-245
41-246

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 3675 online users. [Complete List]
» 2 Member(s) | 3673 Guest(s)
AvatarAvatar

>